crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Clean up the magnet(s) | |
| [* icon_caution] ***Correct magnet alignment is critical. Misalignment of the magnet may result in the controller pressing the LT/RT buttons without any human input.*** | |
| [* icon_reminder] While the magnet does not need to be 100% clean, remove as much as you can. | |
| [* black] After cutting the heatshrink tubing, line up the marks made in the previous step. Practice by hand without tape so you know where to place it before using tape to secure it to the frame. | |
| [* black] Clean up any previous tape used by the factory. If your controller was never repaired, double sided tape was used and should come off relatively easily. If it is difficult to remove, a ***small amount*** of solvent can be used to clean the magnet. A mild cleaner like [https://www.amazon.com/dp/B00006IBNJ/ref=sspa_mw_detail_0?psc=1|Goo Gone] is recommended. | |
| - | [* black] Once the magnet |
| + | [* black] Once the magnet(s) are reasonably clean, line up the alignment marks made in the previous step. Once the alignment is correct, tape the magnet(s) in to make alignment easy for the next step. |