crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Clean up the magnets and triggers | |
| - | [* icon_reminder] Preperation is key for this step. |
| - | [* black] After cutting the heatshrink tubing, line up the marks made in the previous step. Practice by hand without tape so you know where to place it. |
| - | [* black] Clean up any previous tape used by the factory. If your controller was never repaired, double sided tape was used and should come off |
| - | [* black] Once the magnet is clean |
| + | [* icon_reminder] Preperation is key for this step. While the magnet does not need to be 100% clean, remove as much as you can. Alignment and correct magnet placement is also critical with this step. |
| + | [* black] After cutting the heatshrink tubing, line up the marks made in the previous step. Practice by hand without tape so you know where to place it before using tape to secure it to the frame. |
| + | [* black] Clean up any previous tape used by the factory. If your controller was never repaired, double sided tape was used and should come off relatively easily. If it is difficult to remove, a ***small amount*** of solvent can be used to clean the magnet. A mild cleaner like [https://www.amazon.com/dp/B00006IBNJ/ref=sspa_mw_detail_0?psc=1|Goo Gone] is recommended. |
| + | [* black] Once the magnet is mostly clean, line up the marks. Once the frame and magnet are lined up, tape the magnet down and prepare to glue it in place. |