crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Clean up the magnets and triggers | |
| [* icon_reminder] Preperation is key for this step. This is particularly important for magnet placement as it must be installed the correct way. | |
| - | [* black] After cutting the heatshrink tubing, make a mark on the exposed magnet so you know what way it has to be installed. Any mark you can remember will suffice for this. |
| - | [* black] With the mark made, remove the magnet. Clean up any tape residue at thi point, since this will interfere with the glue. |
| + | [* black] After cutting the heatshrink tubing, line up the marks made in the previous step. Practice by hand without tape so you know where to place it. |
| + | [* black] Clean up any previous tape used by the factory. If your controller was never repaired, double sided tape was used and should come off cleanly relatively easily. |
| + | [* black] Once the magnet is clean and the marks are lined up, tape the magnet down and prepare to glue it in place. |