crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Cut the heatshink tubing
+[* icon_reminder] ***If both triggers need repair, do one at a time.***
[* black] Before cutting the heatshrink make two alignment marks that do not cross. These marks will be used to realign the magnets later.
-[* red] After making the alignment marks, cut the heatshrink tubing off of the trigger assembly with a [product|IF145-185-2|Utility knife]. If you need to do this to both, do one at a time.
+[* red] After making the alignment marks, cut the heatshrink tubing off of the trigger assembly with a [product|IF145-185-2|utility knife].
[* orange] Using the old heatshrink as a reference, line it up with new heatshrink tubing and cut two new pieces. Set these aside as these will be needed later.