crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Nickcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Disassemble the controller (Part 1)
-[* red] Remove the batteries from your controller (if installed). ***In order to disassemble the controller, the TR8 bit from the [product|IF145-299-4|64-bit driver kit] is required.***
-[* orange] Remove the screw under the battery cover label. To find this screw, you must puncture the label. It is located roughly in the center of the battery bay where my controller is missing part of the label. Set this screw aside.
-[* yellow] Remove the side trim from both sides of the controller. Once this is done, remove the screws being used to hold the front panel on. Set the side pieces and screws aside.
+[* red] Remove the batteries from your controller (if installed). ***If you do not have a TR8 screwdriver, the bit can be found in the [product|IF145-299-4|64-bit driver kit].***
+[* orange] Remove the screw under the battery cover label. To do this, puncture a hole in the battery compartment where the photo is marked. It is located roughly in the center of the battery bay where it is marked on my controller.
+[* yellow] Remove the side trim from the controller, along with the 4 ***TR8*** screws. Set the trim and screws aside somewhere safe.