crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Metal Snap Installation Using a Hand Presscrwdnd2944351:0crwdne2944351:0

crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Patagonia Snap
Type
replacement
Title
Installing a Metal Snap Using a Hand Press
Introduction
Oh snap! The snap on your jacket just blew out. Fortunately, replacing it is easy. You’ll need the help of a hand press and a new snap. The hand press should be mounted firmly to a sturdy workbench, otherwise it might slip and damage your project or worse yet, injure you.Before you get started, make sure you check the fabric to determine whether or not it’s been damaged to the point where it cannot support a new snap. If the fabric has been damaged, you’ll need to sew a reinforcing patch onto the fabric before replacing the snap.
Time Required Min
crwdns2931287:010crwdne2931287:0
Time Required Max
crwdns2931287:010crwdne2931287:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Easy
Conclusion
Admire your handiwork!
Author
iRobot
Public
crwdns2853045:0crwdne2853045:0

crwdns2943215:0crwdne2943215:0

  • Hand Press x1 added.

crwdns2943213:0crwdne2943213:0

  • Metal Snap x1 added.

crwdns2935255:0crwdne2935255:0

  • Patagonia added.