crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Roborock Q Revo: Laser Distance Sensor Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0DegenFixercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 DegenFixer

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Roborock Q Revo
Type
replacement
Thing
Laser Distance Sensor
Title
Roborock Q Revo: Laser Distance Sensor Replacement
Introduction
This guide will show you how to replace the Laser Distance Sensor (***LDS*** or ***LiDAR***) of Roborock's robotic vacuum Q Revo.
You may want to do so if your robot reports "Error 1: Laser Distance Sensor blocked."
Within the guide I will also outline how to replace just the ***motor*** that spins the LDS, as well as how to clean it properly.
I recommend reading the entire guide before starting the disassembly, then following steps as needed during.
Time Required Min
crwdns2931287:045crwdne2931287:0
Time Required Max
crwdns2931289:01crwdne2931289:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
DegenFixer
Public
crwdns2853046:0crwdne2853046:0

crwdns2933809:0crwdne2933809:0

crwdns2943215:0crwdne2943215:0

  • Phillips #1 Screwdriver x1 added.
  • Phillips #2 Screwdriver x1 added.

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Community-Contributed Guide added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 377557 stepid 377557