crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Prusa i3 MK3 Filament Sensor Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Alexander Collinscrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alexander Collins

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
If you need to replace the filament sensor in your PRUSA i3 MK3, follow the steps in this guide. The replacement is simple and straight forward. All you will need is a 2.5mm hex -bit screwdriver and a new filament sensor. Ensure that you do not lose any of the parts or socket head screws that are removed during replacement.
Conclusion
To reassemble your device, follow these instructions in reverse order. During assemblyreassembly, ensure not to tighten the socket head screws too tight.