crwdns2944351:0crwdnd2944351:0Apple Watch Ultra Sensor Assembly Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2866306:0crwdne2866306:0	Apple Watch Ultra
Type	replacement
Thing	Sensor Assembly
Title	Apple Watch Ultra Sensor Assembly Replacement
Introduction	Use this guide to remove or replace a broken sensor assembly in your Apple Watch Ultra. You’ll need replacement adhesive to reattach the screen when reassembling the device. Your device will function normally, but will most likely lose its IP6X (Ingress Protection) rating.
Time Required Min	crwdns2931287:030crwdne2931287:0
Time Required Max	crwdns2931289:01crwdne2931289:0
Imageid	crwdns2933769:0crwdne2933769:0 crwdns2933771:0crwdne2933771:0
Difficulty	Moderate
Conclusion	To reassemble your Apple Watch Ultra follow these instructions in reverse order to reattach the screen and the battery. Apply a little bit of high isopropyl alcohol (>90%) to a Q-tip or use a cleaning pad to gently remove the leftover adhesive on the edges of the watch case and the screen before installing new adhesive. Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]]. Repair didn’t go as planned? Check out our [link|https://www.ifixit.com/Answers/Device/Apple%20Watch%20Ultra|Answers community] for troubleshooting help.
Author	Dominik Schnabelrauch
Public	crwdns2853046:0crwdne2853046:0

crwdns2933809:0crwdne2933809:0

• crwdns2933811:01crwdnd2933811:0emptycrwdnd2933811:0Safety Requirementscrwdne2933811:0

crwdns2943215:0crwdne2943215:0

crwdns2935255:0crwdne2935255:0

crwdns2933623:0crwdne2933623:0