crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Opening Procedurecrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Dominik Schnabelrauchcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dominik Schnabelrauch

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
Use this guide to open your Apple Watch Series 7 for repairs.
***Note: The opening procedure for the 41 mm and the 45 mm Apple Watch series 7 is the same. You can use this guide for both models.***

This guide shows the procedure on the cellular/LTE version of the watch, but the GPS-only version is similar.

You’ll need ***replacement adhesive*** to reattach the displaycomponents when reassembling the device.
Conclusion
To reassemble your Apple Watch Series 7, follow these instructions in reverse order.
If possible, turn on your device and test your repair before installing new adhesive and resealing.
Apply a little bit of high isopropyl alcohol (>90%) to a Q-tip or use a cleaning pad to gently remove the leftover adhesive on the edges of the watch case and the screen before installing new adhesive.
***To reassemble your device, follow these instructions in reverse order.***
During reassembly apply new adhesive where necessary after cleaning the relevant areas with isopropyl alcohol (>90%).

Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].

Opening didn’t go as planned? Check out our [link|https://www.ifixit.com/Answers/Device/Apple%20Watch%20Series%206207|Answers community] for troubleshooting help.