|
Introduction |
Use this guide to replace a faulty USB port on a Raspberry Pi (Model B Revision 2.0). Within this guide, one should learn to desolder a component (specifically a USB) from a printed circuit board (PCB), to prepare a PCB for soldering, and to solder a component to a PCB. | | So I see you have started exploring the wonderful uses of a Raspberry Pi (Model B Revision 2.0). Seems you have explored enough to develop a faulty/broken USB port. No worries, a USB port replacement is an easy fix. First, you are going to need an adequate workspace and some knowledge of [guide|750|soldering/desoldering]. Nothing fancy, just a well-ventilated space with a clean, stable surface. If you do not already own a soldering iron, I recommend a fine-tipped model. Careful, the iron will be hot; always make sure the iron cord is not in the way of your work. | | | This guide is not a full explanation on soldering itself, but should provide a way to apply this skill to a necessary task. | | If you decide to work outside, position yourself away from the wind; the fumes will remain out of your way. Also if you wear [link|https://www.ee.ryerson.ca/~jkoch/soldering/Soldering_safety.html|contact lenses you must remove them before soldering.] If any fumes or debris were to intermingle with the lenses, they might get lodged and be difficult to remove. | | | Lastly, be patient. The estimated time is only a reference. If you have little experience with soldering, it might take some time to develop a rhythm. Also, if you find a technique that works for you, carry on. This is a learning experience, and a perfect port to practice on! |
|