|
Introduction |
This guide will show you how to replace or install dampers on the Creality CR-10S 3D printer in order to provide some noise reduction while printing. The dampeners are made of rubber material, this will separate the metal frame of the motor from contacting the metal bracket of the 3D printer, greatly reducing the vibrations that create noise.
It is important to note that this process can be replicated for all CR-10 devices with similar stepper motors. | | | === '''Before You Begin''' === | * Ensure that thethere is no power is turned off on yourflowing through the unit and thatby disconnect the power cable is unplugged. | | * Read through the guide to familiarized yourself with the process. | | * Know the location of the components. The above image shows the x-axis components in red and the y-axis components in blue. | | * Remember to be gentle with some of the hardware. Putting too much pressure turning a screw may strip it making it difficult to remove in the future. |
|