crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Creality CR-10S Stepper Motor Dampener Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Hugo Gcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Hugo G

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Introduction
This guide will show you how to replace or install dampers on the Creality CR-10S 3D printer in order to provide some noise reduction while printing.
Note: The above image shows the x-axis of the printer in red and the y-axis in blue.
=== '''Before You Begin''' ===
* Ensure that the power is turned off on your unit and that the power cable is unplugged.
* Read through the guide to familiarized yourself with the process.
* Know the location of the components. The above image shows the x-axis components in red and the y-axis components in blue.
* Remember to be gentle with some of the hardware. Putting too much pressure turning a screw may strip it making it difficult to remove in the future.