crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0MiTM Pressure Washers CA2703HDHB1 2017 Output Assembly Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
MiTM Pressure Washers CA2703HDHB1 2017
Type
replacement
Thing
Unloader
Title
MiTM Pressure Washers CA2703HDHB1 2017 Unloader Replacement
Introduction
This guide will show you how to remove and replace the unloader assembly for the Mi-T-M gas pressure washer. You will need to disconnect many tight pipe fittings in order to disconnect the unloader.
You will need something that is 3” tall to place underneath the pump assembly. This can be a wooden block, brick, etc. This will help brace the pump while you work on removing the fittings.
The following tools are optional, but can help with disassembly:
* 1/4” socket
* 1/2” wrench
* 11/16” wrench
* 3/4” wrench
* 15/16” wrench
* 1” wrench
Time Required Min
crwdns2931273:0crwdne2931273:0
Time Required Max
crwdns2931273:0crwdne2931273:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
When you re-connect the fittings, clean off the old thread sealant and apply new thread sealant (tape or pipe dope).
Author
Arthur Shi
Public
crwdns2853046:0crwdne2853046:0

crwdns2943215:0crwdne2943215:0

  • Adjustable Wrench x1 added.
  • Adjustable Wrench, large x1 Jaws open over 1" added.
  • 6-in-1 Screwdriver x1 added.
  • Wooden Block—3" x1 added.
  • Large Vise x1 added.
  • 8mm Hex Key x1 added.
  • Teflon tape x1 added.

crwdns2943213:0crwdne2943213:0

  • Mi-T-M Unloader 8-0656 x1 added.

crwdns2935255:0crwdne2935255:0

  • In Progress added.