|
Introduction |
You can use this guide to replace athe charging port on the Fusion5 5.5 Gen II device. | | Before you go over each guide step, you should referRefer to this [https://www.ifixit.com/Wiki/[Fusion5_ 5.5_ Gen_ II_ Troubleshooting#Section__Device_Does_Not_Charge|troubleshooting page] so that you can figure out what] to determine if a replacement is the problemnecessary. | | If a charging port on your device get damaged and it is not working, this guide will give you the best way to replace the charging port easily. | | Before you begin, be sure to power off your device and [guide|78998|ground] yourself so that you won’t unintentionally damage the device. | | You need to power off your device and [https://www.ifixit.com/Guide/How+to+set+up+your+Anti-static+mat+and+wristband/78998|ground] yourself before you start the disassembly. | | Because this guide involves soldering, be sure to follow these [https://edu.ifixit.com/project-safety?rq=esd#soldering-safety|soldering safety tips] to protect yourself from hazards that may ensue. If you don’t know how to solder, check out this guide on “[guide|750|How To Solder and Desolder Connections]”. | | Please check [https://edu.ifixit.com/project-safety?rq=esd#soldering-safety|soldering safety] because some steps of this guide requires soldering.
You could know how toTo properly dispose of any electronic waste by referring, refer to thethis [https://www.epa.gov/recycle/electronics-donation-and-recycling|EPA] website. |
|