crwdns2944351:0crwdnd2944351:0How to Grease the Barreto Trencher E718MTH4S 2016crwdnd2944351:0crwdne2944351:0

crwdns2866306:0crwdne2866306:0	Barreto Trencher E718MTH4S 2016
Type	technique
Title	How to Grease the Barreto Trencher E718MTH4S 2016
Introduction	Use this guide to apply grease to the Zerk fittings on the Barreto Trencher E718MTH4S 2016 using a grease gun. There are four Zerk fittings that should be greased regularly: one fitting on each hub (grease every 30 hours of use), the spindle (grease every six hours of use), and the chain roller (grease every six hours of use). You’ll need a grease gun with at least a ten inch hose to reach the Zerk fitting on the spindle. '''Position the trencher on a flat surface and turn the engine and power off before starting any work.'''
Time Required Min	crwdns2931273:0crwdne2931273:0
Time Required Max	crwdns2931273:0crwdne2931273:0
Imageid	crwdns2933769:0crwdne2933769:0 crwdns2933771:0crwdne2933771:0
Difficulty	Easy
Author	Adam O'Camb
Public	crwdns2853046:0crwdne2853046:0

crwdns2933809:0crwdne2933809:0

• crwdns2933811:01crwdnd2933811:0emptycrwdnd2933811:0How to Prepare the Barreto Trencher E718MTH4S 2016 for Servicecrwdne2933811:0

crwdns2943215:0crwdne2943215:0

crwdns2935255:0crwdne2935255:0

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0

crwdns2933815:02crwdne2933815:0

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0

crwdns2933815:03crwdne2933815:0

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0

crwdns2933815:04crwdne2933815:0

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0