|
Conclusion |
| To reassemble your device, follow these instructions in reverse order. You may also wish to [guide|125058|replace the flushing box] at this time. | | | Screw torques from the service manual have been included if you happen to have a torque screwdriver, but don’t worry about them if you don’t. | | | After reassembly, follow the following steps to reset the purge count in order to clear the “Ink Absorber Full” error: | | | # Plug the printer in and turn it on. | | # Press the Home button (the house icon) on the front of the printer until the Maintenance Mode screen appears (approximately five seconds). | | # Hold down the blank button at the bottom of the screen until a number keypad appears on the screen (approximately two seconds). | # Press '''*'''******, '''***2'''***, '''***8'''***, '''***6'''*** and '''***4'''*** (you can use the onscreen keypad or the printer’s built-in keypad for this). The printer will beep and '''***MAINTENANCE'''*** will appear on the screen.
# Press '''***8'''*** and '''***0'''***.
# Press the down arrow repeatedly until '''***PURGE:'''*** (or '''***FLUSHING:'''***) appears on the screen.
# Press '''***2'''***, '''***7'''***, '''***8'''*** and '''***3'''***. The printer will beep and '''***MAINTENANCE'''*** will again appear on the screen.
# Press '''***9'''*** twice to exit maintenance mode and reboot the printer. You can also use this to start over if you make an error.
If this guide was helpful, why not [link|https://buymeacoffee.com/calion|buy the author a coffee|new_window=true]? |
|