crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0MFC-J4410DW Flushing Box Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Calioncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Calion

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
Conclusion
To reassemble your device, follow these instructions in reverse order. If you haven’t already, it’s recommended that you also [guide|125060|replace the ink absorber box] during reassembly.
Screw torques from the service manual have been included if you happen to have a torque screwdriver, but don’t worry about them if you don’t.
After reassembly, follow the following steps to reset the purge count in order to clear the “Ink Absorber Full” error:
# Plug the printer in and turn it on.
# Press the Home button (the house icon) on the front of the printer until the Maintenance Mode screen appears (approximately five seconds).
# Hold down the blank button at the bottom of the screen until a number keypad appears on the screen (approximately two seconds).
# Press '''*''', '''2''', '''8''', '''6''' and '''4''' (you can use the onscreen keypad or the printer’s built-in keypad for this). The printer will beep and '''MAINTENANCE''' will appear on the screen.
# Press '''8''' and '''0'''.
# Press the down arrow repeatedly until '''PURGE:''' (or '''FLUSHING:''') appears on the screen.
# Press '''2''', '''7''', '''8''' and '''3'''. The printer will beep and '''MAINTENANCE''' will again appear on the screen.
# Press '''9''' twice to exit maintenance mode and reboot the printer. You can also use this to start over if you make an error.