crwdns2915892:0crwdne2915892:0
After a crash of the Yuneec Typhoon Q500 4K the camera on the drone is susceptible to breaking. One of the most common problems after a crash is the camera breaks or doesn't it turn on. This guide will instruct you on how to fix the drones camera.
crwdns2942213:0crwdne2942213:0
-
-
Have a look at the wires that are connected to the camera.
-
Sometimes after a crash the wires are pulled out or torn upon impact. Check to see the state of them.
-
If they are torn or camera just isn't working, a piece is needed to override the broken wires.
-
-
-
-
Look for the plug where the override cable is located.
-
-
-
Locate the plug to the drone for the override cable.
-
-
-
Plug the override cable from the camera to the drone to reset it.
-
-
-
If the previous solution didn’t work, a replacement camera may be necessary. To replace it, slide the entire camera off the drone frame.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
Cuesta, Team 10-5, Krynen Fall 2024 crwdns2935289:0Cuesta, Team 10-5, Krynen Fall 2024crwdne2935289:0
CUESTA-KRYNEN-F24S10G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
