crwdns2915892:0crwdne2915892:0
This guide explains how to replace the joysticks in the Yuneec ST16S. The joysticks allow you to control the drone while it is in flight. You can find out if your joysticks need to be replaced by checking out the Yuneec ST16S Troubleshooting.
crwdns2942213:0crwdne2942213:0
-
-
Hold down the button located above the battery while applying downward pressure to the battery.
-
-
-
While still holding down the button, slide the battery out of its slot.
-
-
-
Remove the single screw from the battery compartment.
-
-
-
Remove the rubber bumpers from the back of the device using a spudger.
-
-
-
-
Remove the two screws located under each of the rubber bumpers.
-
-
-
Remove the three screws along the top of the device.
-
-
-
Carefully remove the backplate from the device.
-
-
-
Remove the four screws from around the joystick.
-
-
-
Remove the joystick from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.