crwdns2915892:0crwdne2915892:0
Use this guide to replace the icemaker assembly in your Whirlpool WRS315SDHW Refrigerator.
The icemaker assembly is a combination of parts that creates ice. If your refrigerator isn't producing ice, or is producing too much ice, then your icemaker might be broken.
Note: Some photos show the doors removed for clarity purposes. Removing them is not required and will not change the procedure.
crwdns2942213:0crwdne2942213:0
-
-
Turn off your main water supply
-
Unplug your device
-
-
-
Depending on your repair, open one or both doors.
-
-
-
Pull the icemaker tray completely out of its slot in the chassis.
-
-
-
-
Use a 1/4 inch socket wrench to remove the three screws securing the icemaker assembly (shown with the assembly removed):
-
Two 23.9 mm-long screws
-
One 16.7 mm-long screw
-
-
-
Pull the icemaker assembly toward the right edge of the refrigerator to release it from its slot in the chassis.
-
Let the icemaker assembly hang to access its connector.
-
-
-
Disconnect the spade connector attached to the icemaker assembly.
-
-
-
Remove the icemaker assembly.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0