VTech Kidizoom Smartwatch DX2 Camera Replacement
crwdns2944107:0crwdnd2944107:0Nathaniel Cadycrwdnd2944107:0crwdnd2944107:0crwdnd2944107:04crwdnd2944107:0crwdne2944107:0
crwdns2944111:0December 19, 2018crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0If one of the cameras on your device is broken, cracked, or damaged in any way, the following guide will show you how to replace the camera.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Begin by flipping the watch over with its back facing upwards.
-
-
-
Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.
-
-
-
Gently lift the backplate up to remove it.
-
-
-
After removing the backplate, lift the master switch up from the circuit board.
-
-
-
Using a Phillips #00 screwdriver, remove the 0.6 mm screw.
-
-
-
Carefully remove the speaker from the case without disconnecting it from the motherboard.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the tweezers, carefully lift the bar holding the connection to the screen.
-
Remove the motherboard from the device.
and how to put it back
I'm trying to replace the microphone. Will replacing the motherboard get me a new microphone? I don't see it listed as a replacement part.
-
-
-
Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place.
-
Carefully lift the clips and slide the cameras out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S3-G5, Peak Fall 2018 crwdns2935289:0UMass Dartmouth, Team S3-G5, Peak Fall 2018crwdne2935289:0
UMASSD-PEAK-F18S3G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947410:01crwdne2947410:0
to much and do not under stand it
