crwdns2915892:0crwdne2915892:0
You no longer get sound from the speakers on your tablet. This guide will help you gain access to the speaker on your tablet for removal or replacement.
crwdns2942213:0crwdne2942213:0
-
-
Turn your device to where the back panel is facing you.
-
-
-
Lift the Leg all the way up and twist the bottom to remove.
-
Once the bottom part pops out the whole leg should just come off.
-
Remove any game cartridge from the device.
-
-
-
Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.
-
There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.
-
-
-
Remove all nine screws from the back of the device using a J0 bit.
-
Remove the small battery.
-
-
-
Using a plastic opening tool, detach the backplate from the front piece.
-
Once the backplate has been removed, you will have access to the circuit board.
-
-
-
-
First begin by removing the three cross-head screws using a J0 bit.
-
-
-
First remove the ribbon cables. There are two highlighted by the red squares
-
Do not apply too much pressure and make sure that the black plastic tabs are fully open before you pull the cable out.
-
-
-
Remove the camera from the assembly and put is a safe place so that it will not get damaged.
-
-
-
Remove the board from the main assembly.
-
Be careful not to pull too hard so that the cables aren't broken.
-
-
-
De-solder the points shown to fully remove the cables and free the board.
-
-
-
Desolder these two points from the circuit board.
-
-
-
Remove the two screws that are holding down the speaker.
-
-
-
Desolder the two wires that are connected to the speaker.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 5-1, Lacy Fall 2016 crwdns2935289:0USF Tampa, Team 5-1, Lacy Fall 2016crwdne2935289:0
USFT-LACY-F16S5G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Thank you for this guide. I have a Vtech (ELC) toy flip phone, which has similar issue. I think your guide is incomplete, has only 13 steps and stops at desoldering the speaker. What speaker shall I get, does it matter, or just the size matters? Thank you!
