crwdns2942213:0crwdne2942213:0
-
-
Use a plastic opening tool to remove the two rubber grips on the back of the tablet.
-
-
-
Remove the two 10mm Phillips #0 screws located under the grips.
-
-
-
Flip the tablet over and use a plastic opening tool to pry the casing away from the top of the screen. Push the back cover off.
-
-
-
Once the casing is off, remove the nine 5mm Phillips #0 screws shown.
-
-
-
Remove the white ribbon cable by pulling the blue tab straight up out of the socket and then peeling up the tape securing it to the tablet.
-
-
-
-
Remove the copper ribbon cable by gently using a spudger to pry it up from its socket.
-
-
-
Slide the bottom grey cover piece away from the body and remove it.
-
-
-
Remove the five 4mm Phillips #000 screws.
-
Remove the two 5mm Phillips #000 screws holding the charger in place.
-
-
-
Position the charging port at an angle so you can thread it through the opening as you remove the black plastic cover from the back of the tablet.
-
-
-
Use a spudger to lift the zero insertion force connector latch for the long ribbon cable to the right of the battery, then pull the cable loose from its socket.
-
-
-
Remove the three 5mm Phillips #0 screws securing the original battery.
-
-
-
Use the spudger to pop the battery loose and remove the battery.
-
-
-
Use a spudger to carefully remove the black tape, and gently disconnect the pin connector.
-
-
-
Remove the copper tape securing the Wi-Fi antenna.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947410:01crwdne2947410:0
no mention of disconnecting or re connecting the wiring that comes to the screen on removal ? great illustration though love it, cheers Don