crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the door sensors in your Samsung RF28R7201SG refrigerator.
The Samsung fridge uses a magnetic reed switch for each French door. If these sensors fail, the refrigerator will think a door is always open or closed.
crwdns2942213:0crwdne2942213:0
-
-
Unplug your refrigerator before you begin your repair.
-
-
-
Use a Phillips screwdriver to remove the three 18.5 mm-long screws securing the hinge cover on the top of the refrigerator.
-
-
-
Lift the edges of the hinge cover to loosen it from the refrigerator.
-
Flip the hinge cover over to access the cables underneath.
-
-
-
-
Use your fingers to squeeze and disconnect the blue wire connector.
-
Use your fingers to squeeze and disconnect the white wire connector.
-
-
-
The left door sensor
-
The left door sensor connector
-
The right door sensor
-
The right door sensor connector
-
-
-
Use your fingers to squeeze and disconnect the sensor cable connector.
-
-
-
Use a spudger or a flathead screwdriver to pry the sensor out of its retaining clips.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
Global Fixers crwdns2935289:0Global Fixerscrwdne2935289:0
Community
crwdns2931471:033crwdne2931471:0
crwdns2935297:0571crwdne2935297:0
