crwdns2915892:0crwdne2915892:0
Use this guide to replace a cracked rear camera lens cover on your Samsung Galaxy S20 FE 5G.
A damaged rear camera lens cover may be causing poor quality photos.
Before starting this repair, make sure the issue is with the lens cover and not one of the cameras.
You’ll need replacement adhesive for the back cover and camera lens cover to reassemble your device.
crwdns2942213:0crwdne2942213:0
-
-
Heat an iOpener and apply it to the bottom edge of the back cover for two minutes.
-
-
-
Apply a suction cup to the center of the back cover's bottom edge, as close to the edge as possible.
-
Pull up on the suction handle with strong, steady force to create a gap between the cover and frame.
-
Insert an opening pick in the gap.
-
-
-
Slide the opening pick along the bottom edge to slice the adhesive securing the back cover.
-
Leave the opening pick inserted in the bottom right corner to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the right edge of the back cover for two minutes.
-
-
-
Slide the opening pick around the bottom right corner and all the way up the right edge to slice the adhesive.
-
Leave the opening pick inserted in the top right corner.
-
-
-
-
Apply a heated iOpener to the top edge of the back cover for two minutes.
-
-
-
Slide the opening pick around the top right corner and along the top edge to slice the adhesive.
-
Leave the pick inserted in the top left corner.
-
-
-
Apply a heated iOpener to the left edge of the back cover for two minutes.
-
-
-
Slide the opening pick around the top left corner and all the way down the left edge to slice the remaining adhesive.
-
-
-
Remove the back cover.
-
-
-
Use tweezers or your fingers to peel off the old adhesive from the back cover and frame.
-
Use highly-concentrated isopropyl alcohol (over 90%) and a microfiber cloth to remove any remaining adhesive residue.
-
Follow this guide to apply new custom-cut adhesive.
-
-
-
Apply a heated iOpener to the rear camera lens cover for two minutes.
-
-
-
Insert the flat end of a spudger through the top camera cutout from the underside of the back cover.
-
Push the lens cover until it begins to separate from the back cover.
-
Insert an opening pick between the lens cover and back cover.
-
-
-
Slide the opening pick back and forth under the rear camera lens cover to slice its adhesive.
-
-
-
Remove the rear camera lens cover.
-
Use tweezers to slowly peel off the old adhesive—it won't leave any residue.
-
Use the camera cutouts to find the proper orientation of the lens cover.
-
Remove the plastic liner from the back of the new lens cover.
-
Lay the lens cover in its recess and press down firmly on the entire surface of the cover to secure it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
