crwdns2942213:0crwdne2942213:0
-
-
Place the SIM eject tool in the hole of the sim tray.
-
Push until part of the SIM tray is pushed out.
-
Pull out the rest of the SIM tray.
-
-
-
Gently pry open the area of the back cover near the SIM tray using an iFixit opening pick.
-
Gently move the pick along the gap and pry open the clips holding it together.
-
-
-
Using a hair dryer on low heat, heat the fingerprint sensor in increments of 30 seconds to loosen the surrounding adhesive.
-
Gently push the fingerprint sensor until it detaches from the back cover.
-
-
-
-
Remove the three 3 mm screws from the shield using a Phillips #000 screwdriver.
-
Remove the shield from the phone.
-
-
-
Using tweezers, a spudger, or your fingers, disconnect the battery press connector from the phone.
-
-
-
Use an iFixit pry tool to dig under the battery edge.
-
Continue to cut the adhesive under the battery until you are able to pry the battery away from the phone.
-
Remove the battery from the phone.
-
-
-
Using a spudger, detach the ribbon cable connected to the fingerprint sensor.
-
Remove the fingerprint sensor from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
