crwdns2915892:0crwdne2915892:0
Because this model does not come equipped with speakers, this port can be used to connect external audio equipment to give your monitor sound. If the audio jack is damaged, connected audio equipment will not operate properly.
crwdns2942213:0crwdne2942213:0
-
-
Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.
-
-
crwdns2935267:0crwdne2935267:0Heavy-Duty Spudger$4.99
-
Insert the heavy duty spudger in between the monitors back panel and its frame.
-
Use the heavy duty spudger to pry open the back panel.
Broken some of the tabs case was not exclusive force but the method of force the bottom panel should NOT be pushed towards you. Create seperation all over the bottom side and slowly pull the cover off.
-
-
-
Remove the navigation button connector by pulling while holding down its thumb tab.
-
-
-
-
Remove the screen connector by gripping its sides and gently pulling while wiggling back and forth.
-
-
-
For the ribbon cable, Lift the tab from the side facing the inside of the mother board with your fingernail or a spudger.
-
Remove the cable by pulling while lifting slightly.
-
-
-
Remove each of the 5mm length screws attaching the motherboard to the body of the monitor using a #1 Phillips head screwdriver.
-
-
-
Using both hands, lift the board off of the monitor body by the motherboards base.
-
-
-
Desolder each of the indicated leads on the back of the motherboard.
-
-
-
Squeeze the rear tabs located on the back of the motherboard with your thumb and index finger.
-
While squeezing both tabs, pull the audio jack out from the front of the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S9-G1, Banghart Fall 2017 crwdns2935289:0Cal Poly, Team S9-G1, Banghart Fall 2017crwdne2935289:0
CPSU-BANGHART-F17S9G1
crwdns2931471:06crwdne2931471:0
crwdns2935297:014crwdne2935297:0
