crwdns2915892:0crwdne2915892:0
If you need to reinstall a new LCD Housing unit then use this guide. For his guide, you will need mainly a Phillips #00 screwdriver head and any other tools that were used in the prerequisite guides such as a Spudger or iFixit Opening Tool. Will will not need to do any difficult steps but this guide will be time consuming.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four silicone feet on the bottom plate.
-
Remove the following Phillips screws from the bottom plate:
-
Two 9 mm screws
-
Two 13 mm screws
-
-
-
Remove the bottom plate from the device.
-
-
-
Disconnect the antenna connector by pulling it directly out of its port.
-
Remove the antenna.
-
-
-
Remove the four 9 mm Phillips screws securing the motherboard.
-
-
-
Gently pull the motherboard down until the cables are visible.
-
-
-
Remove each cord by gently disconnecting each connector with your hand.
-
-
-
-
Continue gently removing each cord with you hand.
-
-
-
Finish gently removing the final cord attached to the motherboard to successfully remove the motherboard.
-
-
-
Use an opening pick to pry underneath the plastic covering the edges of the screen.
-
Place an opening tool in the space made between the screen and this plastic piece and pry up, working around the length of this circular piece to significantly loosen it.
-
-
-
The panel should be loosened significantly enough to be pulled off the main body, revealing the edges of the screen.
-
-
-
Remove the two 13 mm Phillips #0 screws on the bottom edges of the screen.
-
Remove the 9 mm Phillips #0 screws on the upper edge of the screen.
-
-
-
On the back of the screen, remove the four 9 mm Phillips #00 screws, disconnecting the LED assembly.
-
-
-
Using a metal spudger, scrape underneath this adhesive and pry up, freeing the cable from the body. Repeat this for the other cable to free the LED.
-
-
-
Remove the two 13 mm Phillips screws securing the LCD assembly.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 6-1, Botvin Spring 2025 crwdns2935289:0UMass Dartmouth, Team 6-1, Botvin Spring 2025crwdne2935289:0
UMASSD-BOTVIN-S25S6G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
