crwdns2915892:0crwdne2915892:0
You will learn how to remove the motor from the base to check for frayed wires and/or loose screws.
crwdns2942213:0crwdne2942213:0
-
-
Take out the three 15 mm Phillips #1 screws.
-
Remove the 15mm T10 screw.
-
-
-
Remove the gray base by lifting upwards and placing to the side.
-
-
-
-
Remove the three 15 mm Phillips #1 screws.
-
-
-
Remove the motor by gently lifting up. Be careful with the cords, as they may be tangled.
-
This is the entire motor for the Ninja. If you have access to a spare motor, simply swap out the motors.
how do you get the top wheel off that spins the blender cup device itself? The part that goes through the plastic housing from the motor?
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 15-1, Remmell Spring 2016 crwdns2935289:0USF Tampa, Team 15-1, Remmell Spring 2016crwdne2935289:0
USFT-REMMELL-S16S15G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Dear sir my ninga kitchen system 1100 (blender machine) motor rod is broken i need help to replace it where i can get the rod or repair shop near me thank you
