crwdns2915892:0crwdne2915892:0
Use this guide to replace the main board (motherboard) in a Motorola Moto G Stylus (2021).
crwdns2942213:0crwdne2942213:0
-
-
Push a SIM tray ejector into the hole.
-
Remove the SIM card and tray.
-
-
-
Power off your phone and disconnect the charger and any peripheries before beginning disassembly.
-
Lay the phone face down.
-
Heat an iOpener and apply it to the rear case.
-
Alternatively, use a hair dryer to heat the rear case until it's almost too hot to touch.
-
-
-
Insert an opening tool into the seam between the rear case and chassis.
-
Once you create a gap, insert an opening pick a couple of millimeters into the gap.
-
Slide the opening pick around the entire perimeter to sever the adhesive that secures the rear case.
-
If you feel excessive resistance, reheat the problem area(s).
-
Remove the rear case.
-
-
-
Use an opening tool to lift and remove the midframe.
-
-
-
-
Use a T4 Torx screwdriver to remove all eleven 3.2 mm screws securing the midframe.
-
-
-
Use an opening tool to lift and remove the midframe.
-
-
-
Remove the black tape covering the connectors.
-
Use an opening tool to lift and disconnect the four press connectors.
-
Use an opening tool to lift and disconnect the two antenna cables connectors.
-
-
-
Use an opening tool to lift and disconnector the front camera press connector.
-
Remove the front camera.
-
-
-
Use a T4 Torx screwdriver to remove the two 3 mm screws securing the main board.
-
-
-
Use a spudger to an edge of the main board.
-
Lift and remove the motherboard.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
