crwdns2915892:0crwdne2915892:0
Use this guide to remove the motherboard cover in the Motorola Moto E4 (XT1762).
crwdns2942213:0crwdne2942213:0
-
-
Insert a fingernail, or spudger, into the notch on the bottom right corner to start separating the phone unit from the back cover.
-
Move to the bottom left corner to pry the phone out of the back cover.
-
-
-
Lift the phone out of the back cover.
-
-
-
Use a fingernail or spudger to pry at the notch at the bottom end of the battery.
-
Lever the battery out of its recess and remove it.
-
-
-
-
Remove the seven 3.3 mm Phillips #00 screws.
-
-
-
Insert an opening pick between the cover and the motherboard at the bottom right corner.
-
Slide the opening pick upwards to open the plastic clips.
-
-
-
Insert an opening pick between the cover and the motherboard at the bottom left corner.
-
Slide the opening pick upwards to open the plastic clips.
-
Pry up the motherboard cover by twisting the opening pick.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
