crwdns2915892:0crwdne2915892:0
Remove the motherboard cover to take out the motherboard.
crwdns2942213:0crwdne2942213:0
-
-
Insert a thumbnail, or spudger, into the notch on the bottom right corner to start separating the phone unit from the back cover.
-
Move it to the bottom left corner and pry the phone unit out of the back cover until you can get a good grip.
-
-
-
Lift the phone out of the back cover.
-
-
-
Use a finger or spudger to lever the battery out of its recess and remove it.
-
-
-
-
Remove the six 3.5 mm long Torx T5 screws.
-
-
-
Insert an opening pick between the cover and the motherboard near the SIM 2 slot where the power buttons are located.
-
Slide and twist the opening pick to pry open the plastic clips securing the cover.
-
-
-
Slide an opening pick between the cover and the motherboard on the opposite side next to the SD card slot.
-
Twist the opening pick to pry open the plastic clips securing the cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
