crwdns2915892:0crwdne2915892:0
Use this guide to replace the back cover of your Huawei P10 Lite.
crwdns2942213:0crwdne2942213:0
-
-
Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.
-
Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.
-
-
-
After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.
-
Flip the rear cover over to the right side of the phone.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a pair of tweezers to remove the sticker.
-
Remove the two Phillips #00 screws.
-
Remove the four 2.5 mm Phillips #00 screws.
-
-
-
Use tweezers to remove the mainboard shield.
-
Use the flat end of a spudger to disconnect the finger print sensor flex cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:015crwdne2935229:0
crwdns2947412:06crwdne2947412:0
Great guide, but how do I move the fingerprint sensor to the new cover?
You need to warm the adhesive so it can be loose
What adhesive should I use? Thank you!
Nice guide! Thanks! I got a little question about the coloring of the back panel. What kind of coloring is it? Is it a coating you can take off, or is it more like a layer of paint you can scrape off? I am wondering, because I want to clear the back of my Huawei P10 lite. I hope it’s possible though.
Can you send me please back cover.
I'm from Nepal .
