crwdns2915892:0crwdne2915892:0
This guide shows how to install toilet seat stabilizers. Toilet seats often do not remain stable despite tightening the seat bolts. Loose toilet seats can pose a danger to the elderly or anyone with balance difficulties. We will show you how to install seat stabilizers to ensure your safety. Installing toilet seat stabilizers is a simple process that most people can do at home.
crwdns2942213:0crwdne2942213:0
-
-
Put the toilet seat in an upright position.
-
Loop the rubber band through the round screw hole in one of the safety bumpers.
-
-
-
Place the longest flat side of the safety bumper against the bottom of the toilet seat adjacent to any existing bumper.
-
Loop the rubber band around the toilet seat so the safety bumper sits flush and securely against the seat.
-
Confirm the placement of the safety bumper and adjust it if necessary. Return the seat to the upright position.
-
-
-
-
Using a 5/64” drill bit, drill a hole in the center of the slotted hole, not more than ⅜ inch deep.
-
-
-
Place one of the screws into the drilled hole and use the screwdriver to tighten the screw only halfway in to allow for adjustments.
-
Remove the rubber band.
-
Repeat mounting instructions on the other side of the toilet seat.
-
Lower the seat and check that safety bumpers are aligned on both sides.
-
-
-
Use the screwdriver to tighten both slotted screws.
-
Screw the anchor screws into round holes.
-
crwdns2915084:0crwdne2915084:0
California State University Bakersfield, Team 5-1, Chiang Spring 2024 crwdns2935289:0California State University Bakersfield, Team 5-1, Chiang Spring 2024crwdne2935289:0
CSUB-CHIANG-S24S5G1
crwdns2931471:02crwdne2931471:0
crwdns2935303:01crwdne2935303:0
