crwdns2915892:0crwdne2915892:0
This guide may be useful for users who are experiencing power issues. This procedure requires a high technical skill in electrical soldering, along with moderate electrical wiring skills.
crwdns2942213:0crwdne2942213:0
-
crwdns2931653:01crwdne2931653:0 Base Removal
crwdns2944590:01crwdnd2944590:05crwdnd2944590:0crwdnd2944590:0crwdne2944590:0
-
Hold the food processor upside down and remove the two screws indicated with a screwdriver. Once unscrewed, remove the two rubber suction pads.
-
-
-
Use a spudger to remove the 4 rubber base pads located at the corners of the device.
-
-
-
Unscrew all 4 screws that are located beneath the pads with a screwdriver and remove the plastic grey base.
-
-
-
Remove the screws indicated with a screw driver.
-
-
-
-
Remove the two screws behind the knob with a screwdriver.
-
-
-
Use a regular nylon spudger to remove the plastic caps at these locations with moderate pressure.
-
-
-
Remove the 4 screws located under the plastic caps with a screw driver.
-
-
-
Lift and remove the plastic gears at the center of the device.
-
Remove any grease residue underneath the plastic gears.
-
-
-
Remove the remaining screws to unhinge the motor located at the center of the device using a screw driver.
-
-
-
Solder the highlighted section of the power cord, and undo the wiring. Using soldering wire connect a new line with the soldering iron.
-
-
-
Connect the other end of your power cord to the motor terminal.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.