crwdns2915892:0crwdne2915892:0
Use this guide if your RC car is not responding to your remote. A receiver uses input information from your remote that it decodes to move the car accordingly.
Before using this guide, try charging the battery for the RC car and changing the AA batteries in the remote.
crwdns2942213:0crwdne2942213:0
-
-
Remove the 4 clips holding down the hard plastic shell of the RC car. Do this by pinching them with your thumb and index finger and pulling away.
-
-
-
Lift the hard plastic shell off of the RC car.
-
-
-
Disconnect the Lego-style battery connector by gripping either side and pulling them away from each other, slowly and consistently.
-
-
-
-
Unfasten the Velcro strap that secures the battery.
-
-
-
Disonnect all connectors attached to the red, plastic receiver.
-
-
-
Remove the 8 mm Phillips #0 screw holding the front corner of the receiver down.
-
Remove the front corner piece.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 6-3, Botvin Spring 2025 crwdns2935289:0UMass Dartmouth, Team 6-3, Botvin Spring 2025crwdne2935289:0
UMASSD-BOTVIN-S25S6G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
