crwdns2915892:0crwdne2915892:0
After months or years of sweat, dust and water your device can become very dirty.
A great problem is non-responsive buttons that can be easily cleaned.
crwdns2942213:0crwdne2942213:0
-
-
Remove the strap
-
Power-off the device
-
Remove the screws on the front using the Torx T4 screwdriver
-
-
-
Remove the screws on the rear using the Torx T6 (or TR6) screwdriver
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the small grey arc on the top of the device with the tweezers
-
-
-
-
With the tweezers, remove the pin connector linked to the screen
-
Remove the screen
-
-
-
Remove the 2 screws on the motherboard using the PH #000 screwdriver
-
-
-
Remove the 2 screws holding the sensor between the buttons on the right side of the case
-
With the tweezers, remove the sensor and detach the case from the motherboard
-
-
-
Remove the seal around the circumference of the watch casing, as you will be handling the casing a lot and you don’t want to risk tearing the gasket.
-
Using the tweezers, remove the circlips around every button very carefully.
-
When the circlips are removed, you can pull the buttons off. Do this step carefully because you will also find a return spring inside every button hole
-
-
-
Clean the case, including the hole of the buttons
-
Clean the buttons and the springs
-
(OPTIONAL) You can lubrificate the buttons before re-inserting them in the case
-
Reassemble the watch
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:09crwdne2935229:0
crwdns2947412:04crwdne2947412:0
Hi,
the battery is visible in the step 5 and step 6.
It is linked to the mainboard with a connector, It’s not soldered. It’s glued to the back cover but, in my opinion, it can be easy replaced.
The battery type is "361-00097-00". The nominal specifications are 255mAh, 0.97Wh and 3.8V
With a quick search on eBay I've found many replacement battery.
I hope this helps
Hi,
the battery is visible in the step 5 and step 6.
It is linked to the mainboard with a connector, It’s not soldered. It’s glued to the back cover but, in my opinion, it can be easy replaced.
The battery type is "361-00097-00". The nominal specifications are 255mAh, 0.97Wh and 3.8V
With a quick search on a the internet I've found many replacement battery
I hope this can help
Me Hulk, me have big meaty Hulk fingers, me no want to smash, me get frustrated, HULK SMASH!¡!!
Hi Jacopo,
I suggest cleaning it with isopropyl alcohol or rubbing alcohol. Another solution is to use a mixture of baking soda and water.
You can apply the solution using a small paintbrush.
