Doss E-GO II Speaker Driver Replacement

crwdns2915892:0crwdne2915892:0

Use this guide to replace the speaker driver in your DOSS E-Go II wireless speaker. This is important because if the speaker driver is not working properly, then the noise will be muffled or nonexistent. Before continuing with this guide, please make sure that your speaker is charged.

Before continuing this guide, make sure to follow up with the troubleshooting page to check for other reasons why speaker buttons may not be working properly. Beware that if the alternative ways don’t fix your button issue, this potential solution requires soldering.

crwdns2942213:0crwdne2942213:0

crwdns2931653:01crwdne2931653:0 Speaker Driver

Doss E-GO II Speaker Driver Replacement, Speaker Driver: crwdns2935265:01crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement, Speaker Driver: crwdns2935265:01crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement, Speaker Driver: crwdns2935265:01crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Peel the backing off of the speaker.
Remove eight 7.9 mm screws using the Phillips #00 screwdriver.
Gently pull apart the grille on the sides of the speaker.

crwdns2913378:0crwdne2913378:0

crwdns2931653:02crwdne2931653:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:02crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:02crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove four 9.6 mm screws from one of the speaker drivers using the Phillips #00 screwdriver.
Gently flip the driver up away from you.
Apply a bead of flux. Press the soldering iron tip firmly to melt the solder.
If you heat the area for more than 10 seconds, the excessive heat may damage the wires.
Repeat for the other speaker driver if needed.