crwdns2915892:0crwdne2915892:0
Removing the Control Housing from the refrigerator.
crwdns2942213:0crwdne2942213:0
-
-
Unplug your refrigerator before you begin your repair.
-
Condenser fan motor
-
Compressor motor and thermal overload device
-
Water supply valve assembly
-
-
-
Open the refrigerator door.
-
Unscrew the light bulb on the rear of the control housing.
-
-
-
-
Use a 1/4" nut driver to remove the two 1/4" hex head fasteners, securing the control housing.
-
Use a 1/4" nut driver to remove the three additional 1/4" hex head fasteners, securing the control housing.
-
-
-
Lower the control housing, allowing the rear portion to stay closer to the top of the fresh food compartment.
-
-
-
Disconnect the control housing by squeezing the locking tab on the connector and pulling the connector downward.
-
-
-
Locate the auxiliary connector and unclip it from the control housing. You may need to push the clip tabs out of the way with a finger.
-
Disconnect the auxiliary connector by squeezing the locking tab and pulling the connector halves apart.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.