crwdns2915892:0crwdne2915892:0
This guide will help users to replace buttons on top of the Digitech XC-5206 speaker system, including: volume controls, power button, and Bluetooth button. Please refer to troubleshooting page before beginning replacement guide steps.
crwdns2942213:0crwdne2942213:0
-
-
Remove front panel by forcefully placing the flat edge of the spudger in between panel and plastic. Angle spudger and use fingers to pry panel off.
-
-
-
Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.
-
Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.
-
OR grab ahold of the silver tab to pull the speaker face out. This may require force.
-
-
-
-
Unscrew upper panel two 10 mm screws spinning a size PH2 screwdriver in a counterclockwise motion.
-
-
-
Remove circuit board by pulling straight upwards out of slot.
-
Remove plastic buttons by gently pushing buttons from top of speaker and using other hand to pull from bottom.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team S2-G4, Munoz Fall 2018 crwdns2935289:0Eastern Washington University, Team S2-G4, Munoz Fall 2018crwdne2935289:0
EWU-MUNOZ-F18S2G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
