crwdns2915892:0crwdne2915892:0
Follow this guide to remove and replace the motherboard in the Dell Chromebook 3100 2-in-1 laptop.
For your safety, discharge your battery below 25% before disassembling it. This reduces the risk of a dangerous thermal event if the battery is accidentally damaged during the repair.
crwdns2942213:0crwdne2942213:0
-
-
Using a Phillips #1 screwdriver, remove all nine of the 5 mm screws from the back cover.
-
-
-
Use the opening tool to pry the back cover off of the device.
-
-
-
Disconnect the battery cable from the connector on the system board.
-
-
-
Using a Phillips #1 screwdriver, remove the three 4 mm screws that secure the battery.
-
Remove the adhesive tape that secures the battery in place.
-
-
-
Carefully remove the battery from the device.
-
-
-
Remove adhesive tape that secures the speaker cable.
-
Disconnect the speaker cable from the connector on the system board.
-
-
-
-
Remove the speaker cable from the retention clips.
-
-
-
Lift and remove the speakers from the device.
-
-
-
Disconnect the keyboard cable.
-
-
-
Disconnect the two input-output board cables from the motherboard.
-
-
-
Disconnect the touchpad cable.
-
Disconnect the USB Type-C power cable.
-
-
-
Remove the single 3 mm screw that secures the WLAN bracket to the system board using a Phillips #1 screwdriver.
-
Lift the WLAN bracket from the system board.
-
After lifting the bracket, carefully unplug the two coaxial cables.
-
-
-
Remove the single 4 mm screw that secures the eDP bracket to the motherboard using a Phillips #1 screwdriver.
-
Remove the eDP bracket.
-
-
-
Disconnect the display cable from the motherboard by using a plastic opening pick.
-
-
-
Remove the five 4 mm screws that secure the motherboard using a Phillips #1 screwdriver.
-
-
-
Lift and remove the motherboard from the computer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Any idea how to use the USB repair shim? Dell's guide didn't help