crwdns2915892:0crwdne2915892:0
You may find it necessary to replace the battery on the CHUWI GemiBook XPro due to its charging rate or capacity. This easy-to-follow guide will assist in the process of battery removal and replacement. For this guide you’ll need a philips #1 screwdriver, the spudger, and opening picks in order to disassemble and replace the battery in an orderly fashion.
crwdns2942213:0crwdne2942213:0
-
-
Orient the device to where you can see the bottom of the case.
-
Use a Phillips #1 screwdriver to remove the twelve 5.6 mm screws that secure the lower case.
-
-
-
Insert an opening pick into the gap between the lower case and the chassis.
-
Pry along the entire perimeter of the laptop until the lower case fully releases.
-
Lift the lower case up and off of the chassis.
-
-
-
Peel off the black tape on the upper-right side of the motherboard.
-
-
-
-
Use two opening tools or your fingernails to carefully "walk" the battery connector out of its socket.
-
-
-
Unseat the speaker wires and antenna wire from their retaining hooks on the battery with a halberd spudger.
-
-
-
Use a Phillips #1 screwdriver to remove the five 4.3 mm screws that secure the battery.
-
-
-
Lift the battery up and out of the chassis.
-
To reassemble your device, follow the above steps in reverse order.
For optimal performance, after completing this guide, calibrate your newly installed battery.
Take your e-waste to an R2 or e-Stewards certified recycler.
To reassemble your device, follow the above steps in reverse order.
For optimal performance, after completing this guide, calibrate your newly installed battery.
Take your e-waste to an R2 or e-Stewards certified recycler.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 5-1, Kilpatrick Fall 2024 crwdns2935289:0University of North Texas, Team 5-1, Kilpatrick Fall 2024crwdne2935289:0
UNT-KILPATRICK-F24S5G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
