crwdns2915892:0crwdne2915892:0
This is a prerequisite-only guide! This guide is part of another procedure and isn't meant to be used alone.
crwdns2942213:0crwdne2942213:0
-
-
Heat an iOpener and apply it to the back cover's right edge for two minutes.
-
-
-
Apply a suction cup to the back of the phone, as close to the middle of the right edge as possible.
-
Pull up on the suction cup with a strong, steady force to create a gap between the back cover and the frame.
-
Insert an opening pick into the gap.
-
-
-
Slide the pick along the right edge to slice the adhesive.
-
Leave the pick in the bottom right edge to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the back cover's bottom edge for two minutes.
-
-
-
Rotate the pick around the bottom right corner to slice the adhesive.
-
-
-
Slide the pick along the bottom edge to slice the adhesive.
-
Leave the pick in the bottom left edge to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the back cover's left edge for two minutes.
-
-
-
Rotate the pick around the bottom left corner to slice the adhesive.
-
-
-
-
Slide the pick along the edge to slice the adhesive.
-
Leave the pick in the top left edge to prevent the adhesive from resealing.
-
-
-
Apply a heated iOpener to the back cover's top edge for two minutes.
-
-
-
Rotate the pick around the top left corner to slice the adhesive.
-
-
-
Slide the pick along the top edge to slice the adhesive.
-
-
-
Lift the back cover from the phone and remove it.
-
-
-
Insert an opening pick between the right edge of the camera bezel and the motherboard cover.
-
Slide the pick back and forth along the edge to slice the adhesive.
-
-
-
Insert an opening pick between the left edge of the camera bezel and the motherboard cover.
-
Slide the pick back and forth along the edge to slice the adhesive.
-
-
-
Lift the camera bezel from the phone and remove it.
-
This is a good point to test your phone's functionality before sealing it up. Use this guide to run a hardware test. Be sure to power your phone back down completely before you continue working.
-
If you are replacing the fingerprint sensor or screen assembly, use this guide to calibrate the fingerprint sensor.
-
Follow this guide to replace the back cover and camera bezel adhesive.
-
-
-
Insert the pointed end of a spudger underneath the tape that connects the wireless charging coil to the speaker on the bottom left of the phone.
-
Slowly lift the spudger up until the tape detaches from the speaker.
-
-
-
Insert a spudger underneath the tape that connects the wireless charging coil to the daughterboard cover on the bottom right of the phone.
-
Slowly lift the spudger up until the tape detaches.
-
-
-
Use a Phillips screwdriver to remove the ten 4 mm screws securing the motherboard cover.
-
-
-
Adhesive secures the motherboard cover to the motherboard itself.
-
Apply a heated iOpener between the bottom edge of the motherboard cover for two minutes.
-
-
-
Insert an opening tool between the motherboard cover and the midframe.
-
Pry up with the opening tool until you are able to grab the motherboard cover with your fingers.
-
-
-
Slowly pull the motherboard cover up and away from the phone and remove it.
-
-
-
Use your fingers to move the graphite film that covers the battery out of the way.
-
-
-
Use the pointed end of a spudger to pry up and disconnect the battery's press connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
