crwdns2915892:0crwdne2915892:0
Use this guide to replace the mainboard on the left controller handle in your Backbone one.
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
-
-
-
Lift up the upper part of the controller.
-
Swing over the upper cover and place it on the controller case.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.
-
-
-
Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.
-
-
-
-
Use your fingers to disconnect the interconnect cable from its connector.
-
-
-
Remove the upper half of the left controller assembly.
-
-
-
Use a Phillips screwdriver to remove the 5.9 mm-long screw which is securing the trigger.
-
-
-
Remove the left trigger.
-
-
-
Use your fingers to remove the left bumper.
-
-
-
Use a Phillips screwdriver to remove the four 3.9 mm-long screws.
-
-
-
Remove the mainboard.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947410:01crwdne2947410:0
In my unit, there were two more screws at step (10), in the upper part of the controller, near the trigger. They may have changed the number of screws used in manufacturing at some point.
