crwdns2915892:0crwdne2915892:0
This guide will show you how to successfully remove the motherboard from your BLU Studio 5.0 II.
crwdns2942213:0crwdne2942213:0
-
-
Locate the small opening on the bottom corner of the back case.
-
-
-
Use your finger to open the back case by slowly pulling it on the open slot.
-
Once the case is lifted on the corner, slide your finger along the edge of the phone to remove the rest of the case.
-
-
-
Locate the opening slot at the bottom of the battery.
-
Use your finger to lift the battery and remove it from the case.
-
-
-
-
Locate the four 3mm screws on each side of the back panel.
-
Use a Phillips #00 screwdriver to remove the eight screws.
-
-
-
Carefully use a spudger to start opening the back case by inserting it between the black and blue lines on the side of the phone.
-
With the help of your fingers, continue to remove the back case by sliding it through the opening.
-
-
-
Locate the following adhesive buttons on the right and left side of the motherboard. These are the volume and power buttons.
-
Use a spudger to carefully separate them from the circuit board.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Locate these two ZIF connectors on the top and left side of the motherboard.
-
Use a spudger to flip up and unlock the black tab on the connector.
-
Use tweezers to pull the ribbon cables out of their connectors.
-
-
-
Locate the indicated connector on the top side of the motherboard.
-
Use a pair of tweezers to gently lift the connector from the circuit board.
-
-
-
Remove the three 3mm screws on the motherboard using a Phillips #00 screwdriver.
-
Use a spudger or tweezers to carefully lift and remove the motherboard.
It would be nice to show some motherboard supply companies…. of course probably avail on Amazon
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2947410:01crwdne2947410:0
that left the speaker disconnected?