crwdns2942213:0crwdne2942213:0
- 
   
   
- 
                     
            
Turn the controller over, exposing the three screws on the back. Use a 6mm screwdriver to remove these screws.
 - 
                     
            
Carefully slide and pull the two parts of the controller shell apart, exposing the innards.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Now that the top of the controller is exposed, the orange, side buttons can easily slide out.
 - 
                     
            
Realign the buttons over the sensors/clean the sensor contacts.
 
 - 
                     
            
 - 
                     
                                                
 - 
   
   
- 
                     
            
Use a spudger to remove the top frame.
 - 
                     
            
Take off the plate.
 - 
                     
            
Remove the rubber buttons.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Pull the circuit strip through the new space.
 - 
                     
            
Realign the top and bottom of the controller.
 
 - 
                     
            
 - 
   
   
- 
                     
            
Return the buttons to the top of the controller.
 - 
                     
            
Snap the frame back into place.
 - 
                     
            
Screw the screws.
 
 - 
                     
            
 
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0