crwdns2915892:0crwdne2915892:0
A quick guide to replacing the motherboard.
crwdns2942213:0crwdne2942213:0
-
-
Remove all ten screws on the back of the laptop to remove the cover.
-
Remove the cover.
-
-
-
Disconnect the wires at the top of the battery by lifting on the tabs protruding out of the plastic frame.
-
-
-
Remove the four screws holding the battery in place, two on top and one on each side.
-
-
-
Gently lift out the battery by the side closest to the motherboard first.
-
-
-
-
Next you will be removing the cpu fan. Begin by removing the nine screws holding it in place.
-
-
-
Then unplug the cable connecting into the motherboard.
-
Right next to the wire that was just unplugged, pull up and release the final clip attaching the fan to the motherboard.
-
Finally lift up and place aside.
-
-
-
Next remove the screws at the top and bottom of the motherboard.
-
-
-
Underneath the battery are 3 cables plugging into the motherboard, 1 wide one and two small ones. Lift the white tabs above them up, and then slide them out.
-
-
-
Next you will need to remove the disk drive. You can follow our guide here.
-
-
-
Move to the top of the motherboard and unplug the two cables that are connected.
-
-
-
Move to the bottom of the motherboard and unplug the single cable near the battery.
-
-
-
Now slide the motherboard back toward where the disk drive was, lift up and turn over. You will see a cable connected to the bottom of the board. Pull back on the dark plastic frame and then remove the cable.
-
Set the old motherboard aside and follow the steps in reverse to install the new one.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S6-G5, Thomas Fall 2017 crwdns2935289:0University of North Texas, Team S6-G5, Thomas Fall 2017crwdne2935289:0
UNT-THOMAS-F17S6G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
