crwdns2942213:0crwdne2942213:0
-
-
Remove ten 3 mm screws using a Phillips #0 screwdriver.
-
-
-
Lift up the back panel and set it to the side.
-
-
-
Using your fingers, grip onto both sides of the wire harness and push it upwards.
-
-
-
Remove the five 3 mm screws holding the battery in place using a Phillips #0 screwdriver.
-
-
-
Tilt the small black tab up which will allow the blue tape to be slid out.
-
-
-
Simply lift the battery up and out of its holding area.
-
-
-
Remove the four 3 mm screws holding the fan in place using a Phillips #0 screwdriver.
-
-
-
Remove five 3 mm screws holding the heat sink in place using a Phillips #0 screwdriver.
-
-
-
-
Pull up fan connector tab by using the plastic handle.
-
-
-
Unwind the cable wrapped around the fan casing.
-
-
-
Disconnect the small cable from the fan.
-
-
-
After all screws and cables are unsecured, lift the fan assembly out of the laptop.
-
-
-
Disconnect the black and white wires by pulling them up.
-
-
-
Unscrew the single 3 mm screw using a Phillips #0 screwdriver.
-
-
-
Slide the Wi-Fi card out of its slot.
-
-
-
Remove the seven screws attached to the motherboard using a Phillips #0 screwdriver.
-
-
-
Using your finger flip the tab holding this light blue ribbon cable and move it out of the way.
-
-
-
Using your fingers lift this tab up and pull out the blue ribbon cable.
-
-
-
Flip up the orange tab beneath the Wi-Fi card and pull out the wire.
-
-
-
Using your fingers, disconnect this wire harness by pushing it out from both sides.
-
-
-
With your fingers, pull this tab up to disconnect the wire from the motherboard.
-
With this tab out of the way you can now pull the motherboard out.
-
-
-
Remove the five screws from the daughterboard using a Phillips #0 screwdriver.
-
-
-
Open the laptop slightly in order for this hinge to open up.
-
-
-
Remove the daughterboard from the laptop.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
