crwdns2915892:0crwdne2915892:0
You can now move on to replacing your keyboard assembly, keep in mind it will take a lot of effort when removing the back panel.
crwdns2942213:0crwdne2942213:0
-
-
Flip the laptop over to the back.
-
Slide the right latch to unlock, then simultaneously slide the left latch outward while pulling the battery out.
-
-
-
Unscrew all twelve 3mm Phillips screws with the J1 screwdriver.
-
Unscrew two 3mm Phillips screws on the black panel using the PH0 screwdriver.
-
Lift the black panel upward by inserting your fingernail in the space provided.
-
-
-
In the RAM and hard drive compartment, unscrew the four 3mm Phillips screws using the J1 screwdriver.
-
Gently pull out the hard drive.
-
-
-
-
Unscrew six 3mm Phillips screws in the RAM and hard drive compartment with the J1 screwdriver.
-
-
-
Pull the CD drive outward with your left hand.
-
-
-
Insert and gently twist the flat metal spudger between the keyboard assembly and the bottom plastic cover so that a small seam is opened.
-
Put in the metal spudger in the seam to hold its place while twisting and levering the flat metal spudger along the whole keyboard.
-
Slowly pry off the back
-
-
-
Unlatch the clip attaching the white flattened flexible cord with a blue tip to the circuit board with your thumb.
-
Pull out the white flattened cord.
-
-
-
Pull back yellow tape attaching the metal colored flexible flattened cord to the circuit board.
-
Lift up the latch at the end of the cord.
-
Pull out the cord to release the keyboard.
Thank you! I only wish I could find a tutorial doing a deep clean on the keyboard itsself due to years of dust! Thanks again!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2947410:01crwdne2947410:0
How do you remove the keyboard from the palm rest is what I'd like to know...what a goofy design